Flight controller

Pixhawk ® 4 is the latest update to the successful family of Pixhawk flight controllers. It is designed and developed in collaboration with Holybro and the PX4 team, optimized to run the full Dronecode stack and comes preinstalled with the latest...

The Flow breakout board is used for motion tracking and can easily be connected to any robotics project or other design.   The motion of a surface, usually the ground, is measured and is reported as delta X and delta Y by the optical flow...

The Flow deck gives the Crazyflie 2.0 the ability to detect its motions in any direction. The VL53L0x ToF sensor measures the distance to the ground with high precision and the PMW3901 optical flow sensor measures movements of the ground...

The Z-ranger deck uses a laser sensor to measure the distance to the ground and adds the possibility to fly with precise height control. Using the ToF sensor VL53L0x the Crazyflie 2.0 can measure the distance from the sensor to a ground object at up...

Add the possibility to read and write files to a SD card. As an example it could be used for high speed logging. Automatic detection of deck via 1-wire memory Designed for mounting above or under the Crazyflie 2.0   Tech Support If you...

Pack of 4 spare motors for Crazyflie 2.0. Mechanical specification: Diameter: 7.0 mm Length: 16.0 mm Shaft length: 3.5 mm Shaft diameter: 0.8 mm Weight: 2.7 g Wire length: 32.0 mm Electrical specification: Kv: 14 000 rpm/V Rated voltage:...

With the BigQuad deck you can transform your Crazyflie 2.0 to a bigger quad by connecting external ESCs (Electronic Speed Controller) to the breakout connectors on the deck. The autodetection of the deck makes this transformation possible to do in...

Sometimes LED feedback isn’t enough, like when you’re flying around in a lab or a living room. With the buzzer deck you’ll get audio feedback on system events, like low battery or charging completed. Or why not create your own...

One of our goals is to make development with the Crazyflie 2.0 as easy as possible. But due to the platforms small size there are limitations on what connectors we can have. Therefore we designed a debug-adapter kit that makes connecting a debugger...